OPERATING MANUAL AND USER GUIDECONTACT 502AWireless Microphone Systemwww.wharfedalepro.com
OPERATING MANUAL9RECEIVER OPERATION:1 Before turni ng on the receiver, make ce r tain the transmitter is off. Also ensure that the volume fo
10Contact 502A5. LOCK and UNLOCK: If you wish to lock the controls on the front panel to avoid accidental adjustments, set the “LOCK/UNLOCK” switch
OPERATING MANUAL11NOTICE:• The position of the antenna will affect the reception, so minimise the distance between the microphone and recei
12Contact 502A1 Unscrew the upper par t (2) of the microphone in a counter-clockwise direction2. Install the two AA batteries according t
OPERATING MANUAL13NOTE: When the microphone is not in use, remember to turn off the power supply. If you will not use the microphone for a long tim
14Contact 502AOscillation ModeCarrier frequencyFrequency StabilityBandwidthFrequency AdjustmentOutput PowerHarmonic radiationMax. adjustment rangeMax.
Wharfedale ProfessionalIAG House, 13/14 Glebe Road, Huntingdon, Cambridgeshire, PE29 7DL, UKwww.wharfedalepro.comWharfedale Professional reserves the
OPERATING MANUALIMPORTANT WARNINGS & SAFETY INSTRUCTIONS1. Please read and retain these safety instructions. 2. Heed all warnings in the operat
2Contact 502Aunits, etc.) BEFORE powering up amplif ier s. Transient voltages from powering up source equipment can damage speakers if amplier
OPERATING MANUAL3Important Warnings and Safety Instructions ... 1Introduction ...
4Contact 502AINTRODUCTIONWharfedale Contact 502A Wireless microphones are the result of many years of experience in the use, design and ma
OPERATING MANUAL5FEATURES • Antenna diversity system with 2 antennas • High sensitivity handheld dynamic microphones with integrated transmitte
6Contact 502AFRONT PANEL OF THE DUAL CHANNEL RECEIVER:Fig.11) POWER: Toggles the power on and off.2) VOLUME CONTROL (Channels A & B): Sets the
OPERATING MANUAL712) Antenna Connectors13) Output B: ¼” unbalanced jack output connector for CH B.14) O UTPUT M OD E Swi tc h: Use “ M I X ED ”
8Contact 502ASETTING UP THE RECEIVEROutput connection:1. Install the two antennas on the rear panel as shown in Fig.3a.2. Connect the power suppl
Comments to this Manuals