Wharfedale Pro R200 User Manual download pdf (Page 3)

Mono & Stereo Input Channels R1604/R2004

The R1604 features 4 and the R2004 fea-

tures 8 low noise, high headroom low

impedance mic inputs for use with bal-

anced or low impedance microphones or

external equipment with XLR connectors.

The R1604 has four balanced/unbalanced

high impedance mono line inputs for use

with high level signals with phoe plug

connectors. The R2004 has eight line

inputs. By pressing the Low Cut Filter

button it is possible to reduce back-

ground rumble, for example on a vocal

track. The input level on the mic chan-

nels is controlled by the Gain Control,

maximising the signal to noise ratio. The

Peak LED will illuminate if the input gain

is too high. When the SOLO button is

pressed, the channel input is shown on

the bargraph meters. Each input channel

features HI, MID and LOW EQ. The EQ

section should be used with the Low Cut

Filter to add extra warmth or punch to

the mix. The two AUX sends are mono

and Post EQ. Pressing the Pre button will

dictate whether AUX1 is sent Pre or Post

Fader. AUX1 is set to Pre Fader for cue-

ing p urposes. AUX2 is set to Post Fader

allowing elimination of any audible

reverb when the fader is pulled down.

The Pan control adjusts the amount of

signal sent to the left versus the right

inputs. On the mono channels the con-

trols act as true pots; Channel 1&3 pan

left, Channel 2&4 pan right. The level to

the main mix is controlled by the channel

level faders with a range to +30dB.

Mono Input Channel R2004

The Stereo Input channels on the R1604

and R2004 feature two balanced line

level inputs with 1/4” jack sockets for left

and right signals. When the left input is

connected only, then the channel oper-

ates in mono. The four stereo input

channels are designed for use with any

line level sources such as CD players and

EFX units. The equalisation on the stereo

input channels have the same parameters

as the three band EQ on the mono chan-

nels but in stereo. The AUX sends are the

same as for the mono channels.

There are two additional Stereo AUX

returns on the R1604 and R2004. If you

connect a jack only to the Left socket it

will operate in mono. EFX return can be

switched between the main mix and the

cue feed by pressing the EFX to AUX but-

ton (see following page Master Section).

AUX Send 1 is automatically assigned to

the main mix. AUX Send 2 can be

switched to ALT 3-4.

Stereo Input Channel R2004

AC Input Power

Switch

Main XLR

outputs

Main

outputs

ALT 3-4

inputs

Channel Inserts

R-2004 Rear panel

1 2 3 4 5 6

Comments to this Manuals

No comments