OPERATING MANUAL AND USER GUIDE
9
12D/15D REAR PANEL FEATURES
1.
Heat Sink:
The heat sink allows for dissipation of heat built up from the amplier via air cooling at the rear
of the enclosure. (Titan 8A MKII and 15D only)
2.
VOLUME for INPUT A and INPUT B:
These knobs control the level of each input channel (Controls the
master volume on the Titan 8A MKII)
3.
HI and LOW EQ (equalization) controls:
These knobs control the equalization of the overall output
signal providing +/- 10dB of gain for each band.
4.
Remote Control:
This Pheonix connector can be used to control the volume with an applied voltage.
5.
90Hz Monitor Filter switch:
Used to reduce bass buildup due to half space loading.
6.
Horn LED defeat switch:
Switches off the horn power LED for discrete applications.
7.
RCA L / R (Left and Right) input jacks:
These jacks allow input of a stereo signal (left and right). The
signal is actively combined or “summed” providing a mono signal to the amplier.
8.
GAIN selection switch:
This switch selects the proper gain structure for INPUT A. If a microphone is
connected to INPUT A, use mic mode (up). If the signal source is anything other than a microphone (playback
device, keyboard or mixer output, for instance) use the line mode (down) .
9 & 10.
POWER ON / OFF switch, POWER ´ON´ indicator LED and LIMIT indicator LED:
The
switch: turns the power on and off. The bracketed LED to the left of the POWER switch illuminates when the
power switch is in the´ON´ position. The LIMIT LED illuminates when the signal limiter is limiting the level of
the signal to prevent distortion and overload.
11.
Output source “LOOP / MIX” switch:
In the “LOOP” mode, this switch routes the signal of INPUT B to
the line level XLR OUTPUT jack, bypassing the EQ section and volume control. When in the MIX mode, this
switch routes the combined (or “mixed”) signals of both INPUT A and INPUT B to the line level XLR OUTPUT
jack.
12.
XLR / ¼” COMBO input jacks for INPUT A and INPUT B:
These convenient jacks allow XLR or ¼”
balanced input connections to INPUT A and INPUT B
13.
POWER cord receptacle:
This is a receptacle for a standard IEC, three prong, grounded AC electrical
connection cord. Be sure that you are plugging into the correct source voltage that matches what is indicated
just below the power cord jack.
14.
XLR line level OUTPUT jack:
This jack provides a balanced line level output for connection to additional
Titan™ ACTIVES, powered subwoofers or ampliers.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals